Skin-Depth Theory Explaining Anomalous Picosecond-Terawatt Laser Plasma Interaction II

The anomaly of ion emission at laser irradiation of targets measured by Badziak et al. was analyzed on the background of the extensive research in the past. In contrast to the irradiation with lasers of longer than 100 ps pulse duration, a drastic decrease of the maximum ion energies was measured with ps pulses. Very strange was the observation that the number of emitted fast ions was intensity independent. The usual ponderomotive or relativistic self-focusing theory and related processes could not explain the results. Instead a direct interaction within the skin depth of the irradiated target was concluded. This model confirms the plane geometry nonlinear force interaction in the ps range producing fast plasma blocks moving perpendicular off or into the target. The block moving into the target opens a new scheme of laser fusion by modifying the experiments of Norreys et al. The use of relatively low subrelativistic laser intensities for the new scheme of laser fusion is evaluated on the background of the long years studies of nonlinear force driven plasma blocks and earlier interpenetration fusion reactions for providing the parameters for expected fusion gains much higher than the experiment of Norreys et al. for a fusion power scheme.     

拖曳线列阵用光纤水听器的研究

报道了光纤水听器用于拖曳线列阵的研究结果。在保证光纤水听器声相位灵敏度的前提下, 优化设计了光纤水听器的结构,降低了光纤水听器的加速度灵敏度36dB。实验测得在20-1600Hz 频段,该光纤水听器的相位灵敏度为-162．7dB,频段内灵敏度的起伏为±0．7dB,加速度灵敏度小于-30dB。     

用拉盖尔-高斯激光对真空中电子直接加速

对用拉盖尔-高斯(LG)光束加速电子作了研究.结果表明，仅模指数为p和l=1的LG光束的纵向电场可用于加速电子.模指数为p和l=1的线偏振和圆偏振LG光束都对电子有加速效果.对轴上光场的相速度和群速度以及电子能量增益等物理特征作了讨论.给出了轴上光场的相速度和群速度、加速电位及电子能量增益等的解析表达式，并作了数值计算和分析. 关键词： 激光电子加速 拉盖尔-高斯光束 线偏振和圆偏振 能量增益     

气垫导轨上运动物体加速度测量方法的改进

利用计数计时测速仪测量气垫导轨上滑块运动的加速度,其测量精度直接依赖于2个光电门之间距离的测量,而在实验中该距离的测量往往不易达到很高的精度,致使加速度的测量精度不高.对计数计时测速仪的电路和单片机程序稍加修改,使之能测出滑块从一个光电门运动到另一个光电门所需时间,就无需测量2个光电门之间的距离,因而提高了加速度的测量精度,节约单片机的资源并缩短运行时间.     

Accelerated glycosylation under frozen conditions

O-Glycosylations using thiomethyl glycosides as donors were compared under both frozen and unfrozen conditions. In the presence of MeOTf as a promoter, enormous rate acceleration was observed when the glycosylation was conducted in p-xylene below its freezing point.     

Experimental verification of drop/impact simulation for a cellular phone

Conducting drop tests to investigate impact behavior and identify failure mechanisms of small-size electronic products is generally expensive and time-consuming. Nevertheless, strict drop/impact performance criteria for hand-held electronic products such as cellular phones play a decisive role in the design because they must withstand unexpected shocks. The design of product durability on impact has heavily relied on the designer's intuition and experience. In this study, a reliable drop/impact simulation for a cellular phone is carried out using the explicit code LS-DYNA. Subsequently globallocal experimental verification is accomplished by means of high-speed photography and impact response measurement. Using this methodology, we predict potential damage locations in a cellular phone and compare them with real statistical data. It is envisaged that development of a reliable methodology of drop/impact simulation will provide us with a powerful and efficient vehicle for improvement of the design quality and reduction of the product development cycle.     

Poly(ortho‐phenylene ethynylene)s: Synthetic accessibility and optical properties

Poly(ortho‐phenylene ethynylene)s (PoPEs) have been synthesized via an in situ activation/coupling AB′ polycondensation protocol. The resulting polymers have been characterized by several analytical methods and are shown to have no structural defects. Although the Sonogashira–Hagihara polycondensation reaction is less efficient than for the preparation of the corresponding meta‐ and para‐linked polymers, presumably because of steric hindrance caused by the ortho substituents, the process can be accelerated by the use of microwave irradiation. Optical spectroscopy indicates solvent‐dependent conformational changes between extended transoid and helical cisoid conformations, providing the first experimental evidence for solvophobically driven folding of the PoPE backbone. © 2006 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 44: 1619–1627, 2006     

Exact coexistence surfaces containing double critical points for a three-component solution on the Bethe,honeycomb, and square lattices

A model is considered in which the bonds of a lattice are covered by rodlike molecules. Neighboring molecular ends interact with orientation-dependent interactions. The model exhibits closed -loop phase diagrams and double critical points. Exact coexistence surfaces are calculated for the model on the Bethe, honeycomb, and square lattices. The nature of the doubling of the critical exponent near a double critical point is calculated. The behavior of the critical line in the neighborhood of a double critical point is calculated exactly.     

Acceleration of the cationic polymerization of an epoxy with hexanediol

Thin films of 3,4-epoxycyclohexylmethyl 3',4'-epoxycyclohexane carboxylate were UV irradiated (1.1 J cm^-2) under isothermal conditions ranging from 0 to 50°C. Under these conditions the polymerization advanced quickly but only to a conversion level of less than 10% before the reaction rate slowed by more than an order of magnitude. This drop off in rate was not caused by the glass transition temperature, T _g, reaching or exceeding the reaction temperature, T _rxn, since the epoxide's T _g remained at least 40°C below T _rxn. Raising the sample temperature above 60°C caused a sharp increase in the conversion level. At 100°C conversion exceeds 80% and the ultimate T _g approaches 190°C. The addition of 10 mass% 1,6-hexanediol, HD, to the epoxy caused the conversion at room temperature to quintuple over the level obtained without the alcohol present. The heat liberated from this alcohol epoxy blend during cure on a UV conveyor belt system caused the sample's temperature to increase by about 100°C above ambient whereas the epoxy alone under these conditions only experienced a modest temperature rise of about 26°C. If the amount of HD in the blend is increased above 10% the heat of reaction at 23°C decreases due to HD being trapped in a nonreactive crystalline phase. Boosting reaction temperatures above 50°C melts the HD crystals and yields significantly improved conversion ratios. As the level of alcohol blended with the epoxy is raised its ultimate T _g is lowered and when the concentration of alcohol in the blend nears 30 mass%T _g drops below room temperature. This revised version was published online in July 2006 with corrections to the Cover Date.     

The distribution of the likelihood ratio for mixtures of densities from the one-parameter exponential family

We here consider testing the hypothesis ofhomogeneity against the alternative of a two-component mixture of densities. The paper focuses on the asymptotic null distribution of 2 log _n , where _n is the likelihood ratio statistic. The main result, obtained by simulation, is that its limiting distribution appears pivotal (in the sense of constant percentiles over the unknown parameter), but model specific (differs if the model is changed from Poisson to normal, say), and is not at all well approximated by the conventional ₍₂₎ ² -distribution obtained by counting parameters. In Section 3, the binomial with sample size parameter 2 is considered. Via a simple geometric characterization the case for which the likelihood ratio is 1 can easily be identified and the corresponding probability is found. Closed form expressions for the likelihood ratio _n are possible and the asymptotic distribution of 2 log _n is shown to be the mixture giving equal weights to the one point distribution with all its mass equal to zero and the ²-distribution with 1 degree of freedom. A similar result is reached in Section 4 for the Poisson with a small parameter value (0.1), although the geometric characterization is different. In Section 5 we consider the Poisson case in full generality. There is still a positive asymptotic probability that the likelihood ratio is 1. The upper precentiles of the null distribution of 2 log _n are found by simulation for various populations and shown to be nearly independent of the population parameter, and approximately equal to the (1–2)100 percentiles of ₍₁₎ ² . In Sections 6 and 7, we close with a study of two continuous densities, theexponential and thenormal with known variance. In these models the asymptotic distribution of 2 log _n is pivotal. Selected (1–) 100 percentiles are presented and shown to differ between the two models.